Features:

Engine startup steps:

1.Open the bottom plate to check the wiring of the engine, connect the fuel tank pipe, and install the three No. 5 batteries to close the bottom plate.

2.Fill the fuel tank with gasoline (95#). When the filling is completed, make sure there is no air in the oil pipe.

3.on the right side of the engine (installation of the flying hammer position), slowly turn counterclockwise by hand to buy more than one turn, its role can make the mixed gasoline fully enter the cylinder.

4.Turn on the power switch and turn the flywheel to start the engine counterclockwise on the right side of the engine (installing the flying hammer position).

Precautions:

1.If the ignition device is normal and the cylinder is under normal compression, if the machine still does not start normally, it is very likely that the carburetor needle should be adjusted.

2.screw the screw on the top of the carburetor, then loosen 1/4 turn, start the flywheel, This can be done several times to make the mixing ratio of gasoline and air reach the normal working mix ratio.

Package Included:

1x Eachine ET6 Model

1x Engine Spare Parts Start Device